Friday, December 11, 2009

How To Make Sinker Molds Melting Lead For Molds?

Melting lead for molds? - how to make sinker molds

What is the best way to lead for lead melt forms, etc.? I do not know how to do it all ...

3 comments:

JD said...

As I said a hand propane tank (Burn-zo-matic) and the National fine.I have done on numerous occasions and I suggest that Mapp gas cylinder (available and nearby propane tanks to the hardware store), a degree Mapp gas burns hotter than a few bob Previous faster.Also .. The Heat lead the forms before pouring the hot ESTROBOS air lead.This stops and has a unitary form of fiber per ........

jonnydol... said...

I can drink a Coleman stove and a coffee to melt the weight of wheels and ballast anchors of small boats. Remember to do this. Smoke from smelting of lead is not very good for you.

gremling... said...

I think you can melt easily with a propane torch. Lead solder is melted with a torch, mixed with tin, and requires a warmer temperature, lead by their regularity should melt with a propane torch. And those who are not so expensive.

Post a Comment